Why Isn’t Your Pulse Unit Detected When Doing Biofeedback Scan

Published on August 2, 2019 by Spooky2 Videos

Most Affordable Rife Machine: https://www.spooky2-mall.com/
Global Rife Community: https://www.facebook.com/groups/spooky2/
Rife Machine Reviews: http://www.spooky2reviews.com/

This video will show you what to do if your computer can’t detect the pulse unit. This video is for software version 20190716 and above.

1. Plug in the pulse unit prior to launching Spooky2. It will not work if plugged in after.

2. Plug in the pulse unit directly to the computer, not via a USB hub. USB hubs add latency which will cause the unit to perform less than ideal if at all.

3. Once you plug in the pulse unit, ensure the Green light is lit solid (shows powered up). Then while wearing the sensor, ensure the red light is blinking (shows when readings are being taken).

4. Now start Spooky2. Go to System tab. There is a “Connected Hardware” panel in the center, which should show a list of all your generators that have been discovered. Along with this list, you should see the pulse listed. If it is not, then you have a connection problem.

Thanks for watching this video. What kinds of videos do you want to see? What other questions do you have? Comment below and we’re more than glad to help!



  • Marian Lydon 4 years ago

    Hi there, there is no mention made of using the TENS pads. Is this optional? Or can you run Pulse without the TENS pads. Thank you.

    • Spooky2 Videos 4 years ago

      Hello, Marian, you need to use contact mode to do biofeedback scan, so you will need TENS pads.


Add your comment

Your email address will not be published.